Defining Waterproofing a Basement.
How do waterproofing systems work in the basement and what exactly are they?
To answer that question, let’s first look at historically conventional basement waterproofing and how it is supposed to work.
If you can see a home being built the contractor first surveys the lot using the blueprints for the home to be built; then he sights out the lot to find out the best place to start digging and grading the property, then he lays the footer or foundation and begins building the basement walls, lastly the balance of the home follows.
The important point to note is the first one in the list above – that big hole in the ground.
When the walls of the basement are built, there is always a gap left outside the walls which needs to be filled. Loose backfill is what is used to fill this void. Well compacted or not, introducing a huge pile of loose backfill is going to cause problems. Water will always flow in the path of least resistance.
This area is going to have water constantly seeping into it. Sometimes, creating a problem is the drainpipe that gets full of silt contained in many systems when waterproofing a basement. As the water comes it brings all sorts of suspension with it and that is to be expected as it is natural. The system can overload if the pipes get over-filled and then the pressure of the built up water would be concentrated on the outer basement walls. Water will work its way through even the smallest gaps, even though basement walls are waterproofed in some way.
The problem of this type is not easily rectified. The reason is that the pipes which are supposed to take away the excess water are gradually getting deteriorated and worsen over time.
A lot of the time a huge mistake is made by not providing access to these pipes. To keep water out of a basement waterproofing is also applied to the external walls. Usually this is called a tanked system.
The drained cavity basement waterproofing system is a better system that works by getting rid of water pressure in the walls. To protect the property water is controlled, collected and then made to pass through hidden drainage channels which are either natural drainage or sump pumps.
Waterproofing a basement is reputedly a better system when they are installed internally, have easy access ports for removing any silt and can be applied to basements where traditional tanking or other methods have failed but with minimal disturbance to the original basement.
So to summarise, a good basement waterproofing system will:
- usually be a permanent or long-term solution
- stop both ways by which water can enter through the walls and up from the floor
- not disturb landscaping, decks, patios, driveways, etc
- usually be an approved waterproofing method for home loans
- often be substantially cheaper than other waterproofing methods
Choose a reputable basement waterproofer when protecting your home, remember it is economically foolish not to waterproof, because the increased value from waterproofing will definitely exceed the cost of the waterproofing.
In conclusion, you want a basement waterproofing system that will deliver:
- a permanent or long term fix
- stop water through the floor and walls
- not disturb the exterior appearance of your home
- an approved method by home loan lenders
- more affordable than other methods
You should look at waterproofing not as an expense but as an investment in the value of your home.